In areas with high humidity, condensation problems often
occur in refrigerant or chilled water pipelines of central
cooling systems. The condensation does not only damage
ceiling,carpet and other furniture, but also waste energy
by higher heat gain to the refrigerant / chilled water pipes.
AEROFLEX Closed Cell Insulation has been widely used in
refrigerant / chilled water pipelines due to the following
superior characteristics :
[] Very low water absorption
[] Low and very stable thermal conductivity (k Value)
[] Non-polar polymer base:high water and moisture resistance.
[] Universal Smoke and Flammability Proof Standards.
[] Flexibility: quick and easy installation.
[] Neat appearance.
copyright 2017
**** IMPORTANT ****
This quick calculation has been made to the best
of our knowledge, as an analysis aid. Neither the
manufacturer of AEROFLEX insulation materials nor,
Engineering Applications Specialists Inc assumes any
responsibility or liability on the use of this software.
Physical properties or chemical properties of AEROFLEX
Closed Cell Elastomeric Thermal Insulation represents
typical average values obtained in accordance with
accepted test methods. However, the manufacturer has
no control over the end applications of these materials,
particularly when used with or attached to other products.
Therefore, the same results as described herein may not be
obtained, or the recommendation made by this quick calculation
may vary due to possible differences in the actual
environments. It is recommended that end user should
consult the manufacturer or authorized distributors
for more information, otherwise, make their own tests to
determine adaptability of material for their particular
application.
Due to continuous development of the products, some
properties are subject to change without notice.
